BBE Supa Charger Universal Power Supply - 8x connectors (9, 12 or 16V), switchable power (120/240V), blue power LED, thomann standard IEC AC cable, includes 8x 2.1mm and 2x 2.5mm cables.
PSA 230/PSA 230 S switchmode power supply 9V DC, 500mA 110-240 Volt 50-60Hz center negative polarity 2.2/5.5mm connector (inside/outside) 305 cm cable lenght power LED weight: 142 g
The DC Brick DCB-10 is the most reliable and consistent way to power your effects board. Forget the collection of unsightly wall warts ... the DC Brick will drive ten pedals or stomp boxes from the same source! More than a power supply, this box is a power conditioner as well. Unlike aging batteries, the Brick supplies predictable voltage at all times, keeping your effects consistent from show to show. Its FCLC (Foldback Current Limiting Circuit) provides ultimate protection against power shorts and overloads. Even at full load, you'll enjoy the quiet and cool operation of a fully regulated power supply. But since battery-powered effects rarely exceed 30 milliamps each, you're not likely to use anywhere near the Brick‘s capacity of 1000 milliamps output! Power: Included AC power adapter can utilize a wide range of international wall power from 100 to 240 volts, at 47 to 63 Hz.
This 9-Volt AC power supply is designed for the Stompbox Modelers (DL4™, MM4™, DM4™, AM4™, and FM4™), POD®, POD® xt, and Variax®. It is intended for use in Europe
MXR MC403 Power System
Powers more types of pedals and electronics at one time than any previous power supply unit available.
Can be used on pedal boards or rack mounted
NEW Visual Sound 1 SPOT Combo Pack Features:
* 1 SPOT 9V DC Power Adapter
* Multi-Plug 8 Cable (New)
* (2) Battery Clip Converters, (2) 3.5mm (1/8”) Converters and an L6 Converter for Line 6 modeling pedals
* Takes up only one spot on your power strip!
* Handles up to 1700mA - the 1 SPOT can easily power your entire pedalboard
* Extra-long 10' cable
* The Multi-Plug 8 Cable connects the 1 SPOT with up to 8 pedals
* Connects to additional cables to power more pedals
* You only need a single 1 SPOT to power your entire pedalboard!
* Compatible with Boss PSA, Boss ACA, DOD PS-200R, Morley 9V, Danelectro DA-1, Dunlop ECB-03, Ibanez AC109, Zoom AD-0006 adapters
* Automatically converts voltage worldwide
For pedals with higher voltage requirements, use this voltage doubling cable with three 2.1mm straight barrel ends to combine two Pedal Power outputs to make 18V or 24V. Ideal for MXR Flanger and Dime Distortion, Crybaby 535Q, various Fulltone and Keeley products.
Pedal Power 2 Plus does it, and does it well, because
any less will degrade your pedal’s performance. Players everywhere upgrade to Pedal Power 2 Plus because it powers what conventional power supplies can’t. Pedal Power 2 Plus is hand made in the U.S.A., comes complete with cables, detachable AC power cord, a 5-year warranty, and simply makes you sound better!
